Tag: Cisco 300-135 Practice Test

Get Full Version of the Examhttp://www.EnsurePass.com/300-135.html Question No.41A customer network engineer has made configuration changes that have resulted in some loss of connectivity. You have been called in to evaluate a switch network and suggest resolutions to the problems. PC2 in VLAN 200 is unable to ping the gateway address 172.16.200.1; identify the issue.VTP domain name mismatch on SW4VLAN 200 not configured on SW1VLAN 200 not configured on SW2VLAN 200 not configured on SW4Correct Read more [...]

Get Full Version of the Examhttp://www.EnsurePass.com/300-135.html Question No.11Refer to the shown below.%LINK-3-UPDOWN: Interface Serial0/0, changed state to up%LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/0, changed state to up What statement is correct regarding the output shown in the graphic?These two log messages will not have a severity level. They are not errors but are just informational messages.The first log message is categorized as a warning message.These messages regarding Read more [...]

Get Full Version of the Examhttp://www.EnsurePass.com/300-135.html Question No.21The following commands are issued on a Cisco Router:Router(configuration)#access-list 199 permit tcp host 10.1.1.1 host 172.16.1.1Router(configuration)#access-list 199 permit tcp host 172.16.1.1 host 10.1.1.1 Router(configuration)#exitRouter#debug ip packet 199What will the debug output on the console show?All IP packets passing through the routerOnly IP packets with the source address of 10.1.1.1All IP packets from Read more [...]

Get Full Version of the Examhttp://www.EnsurePass.com/300-135.html Question No.31Refer to exhibit. The tunnel between R2 and R5 is not coming up. R2, R4 and R5 do not have any routing information sources other than OSPF and no route filtering is implemented anywhere in the network. Which two actions fix the issue? (Choose Two)Redistribute connected routes to OSPF on R5.Change the tunnel destination on R2 to 192.168.2.1Advertise interface Lo0 to OSPF on R5.Configure a static route on R5 to 2.2.2.2 Read more [...]

Get Full Version of the Examhttp://www.EnsurePass.com/300-135.html Question No.1A network administrator is troubleshooting an EIGRP connection between RouterA, IP address 10.1.2.1, and RouterB, IP address 10.1.2.2. Given the debug output on RouterA, which two statements are true? (Choose two.)RouterA received a hello packet with mismatched autonomous system numbers.RouterA received a hello packet with mismatched hello timers.RouterA received a hello packet with mismatched authentication parameters.RouterA Read more [...]